Polycraft 600 is a high viscosity ethyl cyanoacrylate modified adhesive, suitable for bonding a variety of materials such as cardboard, metals, paper, plastics, rubber, wood. Capable of bonding many surfaces including many porous surfaces at a fast speed. Polycraft 600 is also has excellent gap filling capabilities.
Curing Substrates The speed of cure will vary according to the substrates to be bonded. Acidic surfaces such as paper or leather will have a longer curing time that most plastics or rubbers. Low surface energy plastics such as polyethylene / polypropylene require a promoter to aid adhesion.
Polycraft adhesives give best results on close fit parts. Applied in a thin line to ensure rapid polymerisation and a strong bond. Excessive sized gaps will result in a slower cure speed. Polycraft CA700 / CA800 activator sprays may be used to greatly increase the cure speeds.
Polycraft CA700 / CA800 activator sprays can be used in conjunction with the Polycraft 600 for accelerated cure speeds. Speeds of less than 2 seconds can be obtained. Bond strength may be reduced by upto 30% when activators are used.
Uncured Material Properties
|Appearance ||Unit ||Clear |
|Viscosity ||(brookfield) ||1500 (avg) |
|Tensile Strength ||(N/mm2) ||21 |
|Fixture Time ||(seconds) ||5-60 |
|Full Cure ||(hours) ||24 |
|Flash Point ||(°c) ||>85 |
|Shelf Life (@5°c) ||(months) ||12 |
|Max Gap Fill ||(mm) ||0.2 |
|Operating Temperature ||(°c) ||-50 to +80 |
Typical Curing Performance
|Steel / Steel ||<60 seconds |
|ABS / ABS ||<20 seconds |
|Rubber / Rubber ||<15 seconds |
|Wood (Balsa) ||<3 seconds |