Monofil Multi Filler is a high build body filler for both filling and finishing with adhesion to steel sheets, galvanised sheets, aluminium, tin plated substrates and glass fibre reinforced plastics. Short drying time and easy sanding as well as a pore free application by high thickness coatings are further characteristics of this top product
Ensure an adequate supply and exhaust air ventilation. Working temperature must be at least +10 °C. Max. air
humidity 80 %. Polyester-based body filler does not cure anymore at temperature of below +10 °C.
Paint + hardener 100:2 by weight
Ensure an adequate supply and exhaust air ventilation. Working temperature must be at least +10 °C. Max. air humidity 80 %. Polyester-based body filler does not cure anymore at a temperature of below +10 °C.
Object temperature 20 °C Sandable after 20 minutes
Object temperature 60 °C Sandable after 5 minutes
Pot life at 20 °C
3 - 4 minutes
The substrate must be clean, dry and free from grease. Sand the surface slightly. Remove not cured old paint works and priming coats. Do not apply to thermoplastic or acidic products (wash-primer). Mix well the material with the hardener. Do not add more than 3% of hardener Hardener P! Underdosage or over-dosage of the hardener may lead to spotting in the finishing coat. Before each application clean and degrease the whole surface to be painted. De-rust completely damaged areas and dry sand with P 80/150 abrasive paper. After drying, dry sand with P 150/240. Before applying the filler dry sand with P240/360 to a matt surface. In order to fill nonferrous metals (e.g. aluminium, zinced surfaces), the surface can be primed with a suited epoxy-based primer to guarantee an optimum adhesion. Only dry sand putties.