Aerosol spray coat for the protection of propellers and out drives.
Minimum Application Temperature : 5°c
Application Methods :
|Temp ||Touch Dry ||Recoat (min/max) |
|10°c ||40 Min ||9 hrs - none |
|20°c ||20 Min ||5 hrs - none |
Available Colours* :
Preparation & Application
Existing old self-polishing or ablative antifouling: Remove possible oil and grease etc. with suitable detergent, followed by high pressure fresh water cleaning for a thorough removal of any possible weak structure of leached antifouling. Allow the surface to dry before coating.
The surface must be completely clean and dry at the time of application and its temperature must be
above the dew point to avoid condensation. The temperature of the paint itself should be above: 15°C/59°F. Do not apply in direct sunlight. In confined spaces provide adequate ventilation during application and drying.
Previously Uncoated Surfaces
According to specification. Recommended systems are: Hempel Prop Primer or Hempel Light Primer.
Colour stability: Final colour develops after 1 week immersion in water. Length of service may have a certain influence on colour. The antifouling may obtain a copper-green tinge
For further information on technical and safety information please refer to files provided in the technical and safety tab above
The colour's shown should be used as a guide only due to the varying degrees in monitor colour management
For further help and information on what antifouling system to choose please refer to the Hemple antifoul guide in the technical and safety tab above