Properties
Water resistant (EN 204 D3)
Stronger than wood
Ideal for internal and external applications
Transparent when dry
Paintable
Solvent-free
For the water resistant joining and laminating of practically all hard, soft and exotic woods. Suitable for well-fitting, non-load bearing wooden structures using, for example, finger joints, dovetail joints, mortise and tenon joints, dowels and springs. Suitable for indoor and outdoor applications, especially for glue joints that demand water resistance. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface. D3: Interior spaces in which passing water, condensation and / or heavy stress due to increased relative humidity occurs frequently for a short time. Exteriors not exposed to weather influences.
Before Use:
Working conditions
The ambient temperature, the adhesive and the materials to be bonded should be no less than +5°C. Relative humidity of up to 65%. Level of wood humidity between 8% and 12%.
Surface Requirements
The surfaces to be bonded need to be clean, dry and free of dust. Ensure a well-fitting joint.
Preliminary Surface Treatment
Greasy wood types should be degreased with 'Thinner for Bison Kit®' or Thinner.
Tools
Fine-toothed glue spreader (1 mm), brush or roller, clamp or press.
During Use:
Directions for use
Apply the adhesive with a brush or some other tool in an even and thin layer on one or both parts. Let penetrate for a few minutes, then assemble the parts and clamp or press for 30-60 minutes. The desired pressure is 2-5 kg/cm².
After Use:
Stains/residue
Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.
Storage Conditions
Close container properly and store in a dry, cool and frost-free place.
GBP
EUR