Axson Translux D150 water clear epoxy casting resin system, this is a water simulation product and is suitable for floral casting and embedding, it also allows an object to be placed in the middle of the resin without any contact with the walls, with a successive casting to totally encapsulate object, this resin will produce a water clear resin.
Floral Crystal Clear Casting
Floral Vase Water Look
Object Embedding (Various items such as stones, coins and even insects)
Good UV Stability
Self Degassing, Self Leveling
Long Pot Life and Cure Times For Good Air Release
Low And Progressive Curing Process To Reduce The Stress
Please refer to the information and technical datasheet for diagrams of the Shore hardness ratios.
Firm 100/75 is recommended for floral castings, or embedding flowers in a vase for a natural water effect, the firm will level out better to give that water look.
| ||Soft ||Firm ||Rigid |
|Cured Feel ||Soft Rubber ||Firm Rubber ||Rigid Plastic |
|Mix Ratio By Volume ||100 / 100 ||100 / 75 ||100 / 50 |
|Shore Hardness ||D15 / A50 ||D50 / A90 ||D80 / A100 |
|Cured Colour ||Transparent ||Transparent ||Transparent |
|Pot Life (Hours) 21°C ||6 ||6 ||6 |
|Cure Time (Hours) 21°C ||72 ||72 ||72 |
|Demould Time (Hours) 21°C ||120 ||120 ||120 |
|Minimum Casting Thickness ||5mm ||5mm ||5mm |
|Maximum Cast Volume ||2 Litres ||2 Litres ||2 Litres |
For best results ensure resins and moulds are at temperature above 20°C before using, using at colder temperatures will effect cured characteristics and may inhibit cure. Ensure moulds are free from dust and other contaminants. Always perform small test before pouring large amounts to ensure suitability. Keep containers closed when not in use. When stored correctly unopened product has a shelf life of 3 months from purchase. Please refer to technical datasheets for further information regarding usage.