Axson F32 is specifically design to be used for casting fragile parts without the risk of breakage, it is a popular choice for casting patterns, moulds, thin prototypes and scale models and toys. This resin is especially popular with the scale military modeller casting environments. For capturing fine detail this resin is very low viscosity, it have a pot life of 2 minutes and a demould time of 20 - 25 minutes with a full cure of around 72 hours.
- Fast Demoulding Time
- Low Chemical Attack Towards Silicone Moulds
- Good Ability For Being Painted
Mix Ratio by Weight : 100 A : 100 B
Mixed Viscosity mPas : 35
Pot Life (200g, 25°C) : 2 Minutes
Demould Time : 20 Minutes
Shore D Hardness : 72
Flexural Strength Mpa : 48
Flexural Modulus Elasticity : 1100 mpa
Maximum Casting Thickness : 5mm
Glass Transition Temp : 100°C
For best results ensure resins and moulds are at temperature above 18°C before using, using at colder temperatures will effect cured characteristics and may inhibit cure. Ensure moulds are free from dust and other contaminants. Always perform small test before pouring large amounts to ensure suitability. F32 is extremely moisture sensitive, keep containers closed when not in use. When stored correctly unopened product has a shelf life of 3 months from purchase. Please refer to technical datasheets for further information regarding usage.