Polycraft CA700 should be applied to the area to be bonded by spraying. Wait for the solvent carrier to evaporate (normally 10-30 seconds). Apply the Polycraft Cyanoacrylate to the part to be bonded and assemble. CA700 has an on-part life of approximately 1 hour, if parts are not assembled within one hour it should be reapplied.
Alternatively assemble parts using Polycraft Cyanoacrylate then spray exposed bond joint with CA800 to cure adhesive instantly.
The speed of the cure with activator will depend on the substrates being bonded and the adhesive grade.
On Demand curing of Polycraft Cyanoacrylates. Especially suited on slower high viscosity Polycraft Cyanoacrylates 600. Can be used to fillet cure Polycraft Cyanoacrylates and cure adhesive outside the joint
- Main use with wood and rubber
- Cures off Polycraft Cyanoacrylate in adverse conditions
- Sets cure off in seconds
May cause discoloration if used excessively.